I’ve been busy fiddling about with more etched kits. This time a Brassmasters kit for the Deeley 0-4-0 tank engine.  It’s all gone together pretty well with just a few areas that needed a tweak or 2 to get right (if that’s down to an error in the kit or my ham fisted effort to bodge it all together ill leave up to you).  For the benefit of those who might want to try the same kit i’ll share my findings.  On the valve gear the connecting links (part A36 in the kit) are too long and needed reducing in length by about 1.5mm. While the eccentric rods (parts A37 and A38) are also too long and needed shortening by about 3mm.  I didn’t bother using the supplied buffers and new etched heads and replaced them with some A1 models sprung oleos. (part A81) Don’t worry as I know the real loco didn’t have oleo buffers but the A1 models ones don’t look much like real oleos anyway.I found adding the rear lamp irons to be a bit of a faff and lost some anyway. Its much easier to use a bit of fine strip to form a lamp iron with a long foot so that you have something to hold on to while soldering them in place. I decided to make the roof removable by soldering some scrap etch to the edges so that it can be gently sprung into place under the sides.  Brassmaters supply the sides for the earlier flush sided loco as well as this one. I prefered the look of the later ones as it looked more antiquated somehow.I’ve never done valve gear before. The instructions say that valve gear rivets make the job easier but I elected to use brass pins with the heads filed down and located out of view. A slip of cigarette paper and a drop of oil means that the whole lot doesn’t solder together in one big, rigid lump.  I’m pretty pleased with how it came out if I am honest.