One of my slow burning projects has been a humble little 57xx tank.  A combination of the old (But essentially quite good) Mainline body and a High Level Kits chassis but with a bit of twist.

Iain Rice wrote about these back in MRJ 61 and 62 using a similar route, in his case using a Perseverance chassis as that was what was available around the time, and I would urge readers to refer to this as a start point.

The High Level chassis

Like all of Chris’ chassis this was a joy to build (this is my 4th of his chassis kits now, who would have thought it?) I opted to use Brassmasters bearings which may have messed the alignment up a little as I found I needed to mount the break gear 1 mm lower than as supplied.  Strangely though the buffer height seems fine. I differed a little bit from the instructions by making all of the brake gear removable.  The rear rods that go behind the wheels seems to trap the rear axle in place as supplied.

Eagle eyed viewers might spot something little odd and yes, you’ve guessed it – I’ve gone off piste again.

A couple of prototype pics from the Severn Valley.  Personally i though the inside motion was pretty obvious looking at the real thing and while there is a representation of it in the High Level Kit I wanted it to move.

So this is a mish mash of bits – Brassmasters 4f bits at the axle end and Finney GW bits at the front.  The GWR version of inside motion seems much simpler that the midland one and the hardest part of this task wasn’t putting it all together but getting it in place.  Being a small loco theres not a huge amount of wiggle room.

The body is essentially good, you could say extremely good for its time.  The obvious stand out bit of weirdness was the top of the dome but nothing a spot of filing can’t sort out. It did come with a separate main handrail and some wire ones around the bunker but they were all a bit heavy so i replaced those along with those handrails that were moulded on. I reduced the size of the front wheel splasher by cutting it off and gluing it back on, The width of the cut being all you really need.  I didn’t feel the need to fiddle with the centre and rear ones.  While on my 94xx I replaced all the pipework under the tanks in front of the cab with this model I thought it was good enough as is, although I have cut away the ‘holes’ as per Iain’s article.   Theres a bit more detailing to add to the footplate yet and the lower pipework will need to be replaced.